How To Install Bathroom Sink Drain Flange References

How To Install Bathroom Sink Drain Flange

Here are the installation instructions:If playback doesn't begin shortly, try restarting your device.In fact, most solid surface countertops with integral sinks (such as corian) require silicone on basket strainers and garbage disposal assemblies.In order to perform the removal of the flange, you will need to access the sink from the bottom.

Make sure you kneed, warm and roll the putty before making the ring around the underside of the drain flange and press well into place.Next, find the washer that will fit onto the drain under the sink.Next, put a thin bead of silicon around the lower lip of the sink and set the sink in place.No washers are required here.

Once you have removed the bathroom sink drain flange, you can replace it with a new one.Place a slip joint nut on the pipe first, followed by the washer.Push the drain tailpiece back up into the sink's drain from below and screw it into the flange tightly.Remove locknut, friction washer and sink drain washer from drain body.

Step 1 first install a 1/4 in diameter bead of plumbers putty around the underside of the sink drain flange where it makes contact with the sink.Test both faucet handles to ensure water is shut off.Thank you for your question.The diameter of these drains is 2 inches.

The first step is to look under your sink.Then, thread the lock nut and tighten it by hand.This bathroom sink drain features:This is because the oils in plumbers putty can discolor the material.

This is in the sink drain basket.This isnt an issue with a stainless steel.Thread the locknut onto the drain body and install the drain body .Tighten the locknut and turn the drain body to the rear .

To proceed, you’ll need to use a pair of.To start, make sure that the retaining nut is off.Turn off the water, replace the aerator and check for leaks in the water lines.Use a wrench to tighten it up securely.

When you install the drain, gently, firmly and keeping drain plumb (vertical and perpendicular to the sink, press the drain down to start the putty squish and form a seal then tighten the nut.While holding down the drain flange from above, slide the replacement gasket up against the bottom of the sink.You need to either get a 1 ½ or 1 ¼ inches tailpipe to be able to connect to it.You simply slip a nut onto the waste drain and press it against the other pipe, then hand tighten the nut.

You will only need to use silicone caulk underneath the drain flange for strengthening.You’ll note one of them is much too loose, but the other one fits just right.